×

Loading...

网上有人这么说,好像有道理

mocarly (放下)
Normally, when the fan is set to "auto", if the unit enters "heating" mode the burner ignites then a heat sensitive device sends a signal to a relay which turns on the fan. The fan pushes heated air into the plenum and through the ducts but it also removes heat from the combustion chamber, so if the fan does not start or fails during operation, the burner shuts off to prevent overheating, damage, fire, etc.

If your fan is not coming on it could be a bad heat sensing device or a bad relay (the fan motor and power supply seem fine as you state that it works under other circumstances).

You did not state whether or not the burner continues to operate without the fan running, if this is the case you may have an additional problem if your system is designed (as most are) to shut down the burner upon fan failure.
(#11802860@0)
2018-11-20 -04:00
This post has been archived. It cannot be replied.
Page address has been copied.
To share, click to copy page address.
Share Online by QR Code

Back To Topic: 控制器打在''fan auto'' 时,暖气的风扇呜呜地响就是不送风 ;打在''fan on ''时,过了设定的温度又不停止送风 。请问各位行家们,是该换风扇了还是控制器 ?

Back To Forum: HOME枫下论坛枫下论坛主坛枫下家园美丽家居